Xebec Meister Finish Abrasive Ceramic Stones
Universal Series
XEBEC Meister Finish Ceramic Stones
The benchmark series of the XEBEC range for fine polishing and deburring of molds and dies. The ceramic fiber structure maintains consistent cutting performance and allows shaping the tip to match workpiece geometry.
Features
When to choose Meister Finish
The broadest range for fine polishing and deburring of molds and dies, available in flat and round sticks.
- Broad range of cross-sections and lengths.
- Flat sticks for slots, ribs, and sharp edges.
- Round rods for profiles, radii, and holes.
- Manual use, with stone holders, or compatible power tools.
Clear sizes
Main formats, part numbers, and grits
| Size / Format | Part numbers or range | Equivalent grits |
|---|---|---|
| Thin sticks | 0.3 / 0.4 / 0.5 / 0.8 mm thickness; 4, 6, and 10 mm widths; 100 or 150 mm lengths. | 220–1200 depending on size. |
| Standard sticks | 1 / 1.5 / 2 / 3 mm thickness; widths from 1 to 10 mm; 100 or 150 mm lengths. | 80–2000 in GDS catalog, depending on size. |
| Round rods | Ø 1, 1.5, 2, 2.34, 3, and 6 mm; 50, 100, or 150 mm lengths. | 220–1200; availability varies by diameter. |
Full details of all combinations are available in the GDS catalog. The link opens the most relevant page directly.
Working method
Practical guidelines
Apply the tip
In flat sticks, cutting capability is concentrated at the tip: work at an angle of approximately 45°.
Shape when needed
The tip can be shaped with a diamond disk to fit slots or profiles.
Proceed step by step
Each grit must eliminate scratches from the previous grit before moving to the next.
GDS Catalog
Part numbers and availability
Check the section dedicated to Meister Finish in the GDS catalog.
Original catalog
XEBEC technical deep-dive
Official descriptions, operating instructions, and international range.
FAQ
Questions about Meister Finish
Is Meister Finish suitable for hardened steels?
It is primarily intended for materials under 57 HRC. For harder materials, XEBEC Diamond is recommended.
Can it be used dry?
Yes, but a metal polishing fluid can reduce clogging and improve efficiency.
Does it achieve a mirror finish directly?
No: it prepares and refines the surface. Mirror polishing typically requires subsequent steps using lap carriers and diamond pastes.
Other XEBEC series
Compare alternatives
Want to test it on your application?
Provide details on material, hardness, geometry, tool used, and required finish. GDS can assist in selecting the right size and grit.
